News

The working principle of the commonly used air conditioner is that a low boiling point working medium called refrigerant circulates in the four refrigeration components (compressor, condenser, throttle valve and evaporator). The compressor sucks in low-temperature and low-pressure refrigerant gas, which is compressed into high-pressure and high-temperature gas and discharged to the condenser and cooled by the cold air discharged by the axial fan, so that the high-pressure and high-temperature gas in the condenser condenses into liquid, which is then throttled by capillary tube and changed into low-pressure and low-temperature liquid to enter the evaporator and vaporize, absorbing the heat of indoor air sucked by the centrifugal fan to cool the indoor air. Under the action of centrifugal fan, the cooled indoor air is returned to the room through the air duct. When the air flows through the evaporator, because the surface temperature of the evaporator is lower than the dew point temperature of indoor air, the water vapor in the air condenses into water when the temperature drops sharply, drops into the chassis of the air conditioner, and is led to the outdoor through the drain pipe. This reciprocating cycle can adjust indoor temperature and humidity. The purification of air depends on the filtering device in the air conditioner. The filtering device consists of an air inlet grille and a filter screen. The filter screen is generally made of polyurethane foam plastic, which has good dust filtering effect on air. An air conditioner is a device for sending air into or out of a room. It is part of the heating, ventilation and air conditioning (HVAC) system of a building, and can usually be found in any occupied room in a building. When the furnace or air conditioner heats or cools the air, the blower introduces the air into a series of air supply ducts. There is an air conditioner at the end of each air supply duct as a transition between the duct and the room. Another group of air conditioners is located at the top of each return air duct, and the return air duct is an important part of most HVAC systems. According to the design of the room and the configuration of HVAC system, air conditioners can be installed on the ceiling, floor or wall. Some of them can be installed in the ceiling of the bulkhead at or near the soffit, while others are designed for installing the bottom plate. In many structures, the installer places the air conditioner directly under the window to minimize condensed water and maximize the comfort of occupants. The location of the air conditioner will also be affected by local building codes or existing construction conditions. Air conditioner. Each air conditioner has some form of vent or opening, so that ventilation determines the modern vent. It can also include vanes for adjusting the airflow direction, and it can also include vanes for adjusting the airflow direction. Air enters the room at a certain angle instead of in an uncontrolled way. Manufacturers make air conditioners with various materials, including metal and thermoplastic. Installers usually choose registers that match the surrounding rooms. Some can be painted to match the wall or ceiling, while others have polished or brushed metal finishes. When choosing pretreated models, buyers should look for finishes that match other hardware in the space. As time goes by, the performance of the wind collector may be affected by the accumulation of dirt and dust. In order to keep the HVAC system running normally, the owner must clean and maintain these air conditioners frequently to remove dirt and debris. Generally speaking, it is much easier to replace the air conditioner than to repair it if the air conditioner is damaged or seriously blocked. Most standard air conditioners are cheap, and disassembly and installation do not require much effort

China SNS Pneumatic was founded in 1999 which now has been the leading supplier of pneumatic components in China. The company covers an area of 30000 ㎡, having 5 production bases and more than 20 subsidiary companies with more than 1000 employees.SNS has passed ISO9001 and 2000 Quality Management System Certification because of its good service and high quality. By now there are more than 200 agents and distributors all over the world and we are looking forward to approach more international market.

Company: China SNS Pneumatic Co., Ltd.
Address: No.186 Weiliu Road, Economic Development Zone, YueQing, Zhejiang, CHINA
E-mail: zoe@s-ns.com
Phone: 057762768118

https://www.sns1999.com/